Align TREX 700E V2 Manuel d'instructions télécharger pdf (Page 32)

5.LlMIT rudder servo endpoint setting

LIHITJlte~ ••

ff••••

Press and hold the SET button for 2 seconds to enter the setup mode, then press the SET button repeatedly to select LIMIT setup

mode, as indicated by the lighting of LIMIT LED. Push the transmitter rudder stick left until tail pitch slider reaches the end, then

center the rudder stick and wait 2 seconds for the STATUS LED to flash red. Then push the rudder stick right until tail pitch slider

reaches the end, then center the rudder stick and wait 2 seconds for the STATUS LED to flash red. This completes the left and right

endpoint limit adjustment of servo travel. Insufficient servo travel will degrade helicopter performance, while excessive travel will

cause binding and damage rudder servo.

~w"sET"m2~liAJJJlre~:lE1I:t'C. JIt~~jQJH&~~~~1:Ecprr.~9'ilmn . MLiMITlWm. mD7JjOJ~mm9'ill1~~ih . iie~~f!llJM§l!~J~iIl!I9'il;l\:~

IlHM~• ~m;~[Q]~cpTIl)l'i1J. ~2'»~"STATUS"Fs5nm.;;j\G~tl11. ~5n~iQ!J~.88G1'I : m~~~GjOJ£~ih~Jm~;I\:~IlHM~ . j:Ij~m;~

[Q]~cprrl5l'ih . ~2'»~ "STATUS"~~7.i'Wf1~~tl11• 1l07'[;PX~£~.8lI::lE. ~.l',(E~.Mll'8m~~m!OOIre . fflH:~;I\:~~pxjQJH&~mlll

RUD~

Mode

RUD~

IMode

Push the rudder stick right until tail pitch slider reaches

the end, then center the rudder-stick and wait 2 seconds

for the STATUS LED to flas red. his completes the

rudder endpoint limit adjustmentfor the right side.

~7JjOJ~~~l1£mih·~~m~~£~~;I\:rr~IlHM~·~m;~

[Q]~CP:rr!Ol'ih. \:;2~·STATUS~5nm~5n£~rr~8GIr!.7'[;px

Tail gears

~Q'Biim

Push the transmitter rudder stick left until tail pitch slider reaches

the end,then center the rudder stick and wait 2 seconds for the

STATUS LED to flash red. This completes the rudder endpoint limit

adjustment for the left side.

~7JjOJ!II£mtll1~i1J . iie~f!llJmjj~J~!II£jl;l\:m~IlHM~. ~m;~[Q]~cprrl5

l'ih . ~2'»~"STATUS"li\l:i~~tl11~5n~~~8Gm:E:7'[;px

ode avel limit setting lower than 50% will not be

regis ered. Mechanical fix (moving link ball closer to

-center of servo horn) is needed for excessive servo travel

when LIMIT function is below 50%.

~!II£rr~.ffil:lE1'01!£~50% . 6~U3GXFlybarless~l':Y8Gm .

• ~rr~:E:ffil:lE~·~~~m~.~~~;I\:rr~·~~~jQJ~~9'il

~~jOJ~~ih·~~rr~l',(E~.ll'8m~ttlreo

6.Helic()pter~i;ze-aJ1.d ELAY settings

_". •• itPQD.EL

mftilJiiE ••••

This setting i c udes two functions :

(1) For small helicopters such as T-Rex 250/450, set this setting to small helicopter (STATUS LED red).

For larger helicopters such as T-Rex 500/550/600/700 set this setting to large helicopter (STATUS LED green).

JltBlUE158JliHfiWIlIl:

(1)3GXFlybarlesS5Zm/J\l!lI./lit{ml!ll.~~~~. ~BX11!1~~.9'illll!ll.~lt~i39'illl:t'C .

llO :

T-REX250/450~lWlt/J\l!lI./lit{ml!ll.lI:t'C(8lI::lE~"STATUS"Fs~ml.mIRI1"9):

T-REX500/550/600/700~~CP;l\:l!lI.~~.tI:t'C (8lI::lE~"STATUS"Fs~ml.m~1"9)

Select by moving the rudder stick left and right

ti£ ••

75Ifi£II11

RUD

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Align TREX 700E V2 Manuel d'instructions Page 32

Commentaires sur ces manuels