--------------~---- --------_
..•
_-----
'18 ..
3GX 'FLYBARLESS PREFLIGHT ·CHECK
moiifll!lU~
4L:IGN
IStep1
~.1
Turn on Transmitter, and then receiver power.
~
~~~~=:J[~PTI~~~~~~~~~==
~OO~~~~c~,~~~m~~.~·
IStep2
~.2
3GX
Flybarless system will go through initialization process, as
indicated by flashing of all LED's. Do not move the helicopter or
transmitter sticks until initialization process completes.
1lt1Ji!j3GX
Flybarless~1IJIJ~ffi~mSTATUS&DIR-A.REV~~11J '
~o/.J~i1J~¥fI!~lii1Jm~ , p..aull'e~jj~BI~lii\m~H~~~ •
IStep3
~.3
The completion of initialization process is indicated by the rapid
up and down motion of swashplate 3 times while remaining level.
Should the swash plate jumps up and down at a tilted position,
the flybarless system initial setup need to be performed again.
(Refer to page 26: Flybarless system initial setup)
The pitch of helicopter will remain locked until successful
initialization. If the initialization process is unable to complete, with
STATUS LED blinking red, Re-check all connections, and perform
( another reboot with helicopter remain stationary.
Following successful initialization , green STATUS LED
indicates rudder is in heading lock ile red LED indicates
( normal non-heading mode. (Refer to in Adjustment)
=1R..'~~~.6X1m
Jm.ljIIlH*I!1CW:
Swash plate jumps up/
down 3 times horizontally
+~K7J<.ljI~~i1J31R..
o
=
D
=
~
o
rml!~~STATUS
'Oi~~mwr~lI·
f.mil!tiE~tC' ;%nmf.m~Fm~~tC •
o
Green
=
rudder in'heading lock mode
Red
=
rudder in normal mode:':
>
&m~~lel!lE~it -
""<;:::-:;
nm~~fZ~FitlIlE~it .' -
I
Step4
~.4I
Tilt the helicopter forward and swash plate should tilt back to
compensate. If reversed, perform the f1ybarless initial setup again and
adjust the elevator reverse setting (Refer to page 28 E:REV setup)
~~~l!jUuM ' ll'e~jjBl~+~M![5J~~IE ' jzD~&[5J, mwrlii\Flybarless
~~~tC~~ft~MeIl'e'lmjj~IED[5J·
(~$~m28~
E.REVft~m8We~IWHi
IE&[5J~~~tC)
Helicopter tilting direction
I!RM~D[5J
D
Helicopter tilting direction .
I!ltjtl!~D[5J .
35
Commentaires sur ces manuels